ICO 4-7
press (3). For more information, refer to page 5-
35.
d. Press (4) to enter the customer name. For more
information, refer to page 5-35.
e. The oven features a System Information function that
outputs a listing of operating parameters to the
serial communications port once each second, either
anytime the oven is powered on or only during a
burn cycle. As shipped, this feature is turned off. To
turn the system information output on or off, press
(5). For more information, refer to page 5-36.
f. Press
(ESC) to return to the MAIN MENU.
7. Press
(1) to access the Burn Setup Menu. For more
information, refer to page 5-4.
a. Press (1) to access the Burn Parameter Menu. For
more information, refer to page 5-4. Set the burn
mode to Program Time or Auto-Control, as desired
(the default setting is Auto-Control). Set the desired
burn time and/or cutoff limit. Set the calculation
type to bitumen-to-sample or bitumen-to-aggregate,
as desired (the default is bitumen-to-sample). Select
the desired burn profile. Press
(ESC) to return to
the Burn Setup Menu.
b. The oven features an Auto-Print function that, when
turned on, automatically prints sample data during a
burn cycle. As shipped, this function is turned on. To
change the status of the Auto-Print function, press
(2). For more information, refer to page 5-10.
c. The oven also includes an Auto-Store function that,
when on, automatically stores sample data in the
active project upon completion of a burn cycle. As
shipped, this function is turned off. To turn the Auto-
Store function on, press
(3). For more information,
refer to page 5-12.
d. Press (ESC) to return to the MAIN MENU.
To Next Page
Loading...