5-18
hh:mm AM
Arrows toggle AM/PM
Input Start Time
then press ENTER
The top line of the display shows the current setting for the start
time. The time format (in this example, the AM/PM format) is
the same as that displayed on the default screen. To change the
time format, refer to page 5-34. Use the numeric keys to enter
the desired start time and the arrow keys to toggle between AM
and PM. To move the cursor back one position, press the
(BACK SPACE) key. When finished, press (ENTER).
NOTE
The start time should be set at least 60 – 90 minutes
before the first sample is to be burned. To ensure
consistent, repeatable results.
If the start time is valid, the oven requests the stop time for the
Auto-Timer as shown below. The stop time is the time of day
when the Auto-Timer is to turn the heating element off.
hh:mm PM
Arrows toggle AM/PM
Input Stop Time
then press ENTER
The top line of the display shows the current setting for the stop
time. Use the numeric keys to enter the stop time and the arrow
keys to toggle between AM and PM. To move the cursor back
one position, press the (BACK SPACE) key. When finished,
press
(ENTER).
If the stop time is valid, the oven displays the Auto-Timer
Enabled screen, showing the start date and time, the stop date
and time, and the days to be skipped (if any). If no days are to be
skipped, the bottom line of the display is blank.
To Next Page
Loading...
Need help?
General
