Model 2701-B 2–13
2. GETTING STARTED
MIX CALIBRATION
The Mix Calibration function is used to adjust gauge measurements,
as described on page 3–6.
LAYER THICKNESS
The Layer Thickness function enables the operator to enter the
thickness of the material being measured. When this function is
enabled, the gauge prompts the operator to enter a thickness value
when creating a new project as described on page 5–4. The layer
thickness value is then stored along with other measurement data in
the active project.
To enable or disable the Layer Thickness function, press 〈8〉 on the
Setup menu shown on page 2–7. The gauge displays:
Thickness Option
1. ON
2. OFF
Press # to Select
Press 〈1〉 to enable the Layer Thickness function or 〈2〉 to disable it.
The gauge sets the function to the desired state, displays a brief
confirmation message, and returns to the Setup menu.
To Next Page
Loading...
