5–4
CREATE A PROJECT
To create a new project, press 〈3〉 at the Project menu shown on
page 5–2. The gauge displays:
Project Name
<ALPHA> for Letters
<ENTER> to Exit
Press the 〈ALPHA LOCK〉 key to enable the alphabetic keys on the
gauge. When the alphabetic keys are enabled, the symbol A appears
in the upper right of the display, as shown above.
Enter the project name (up to twelve characters) and press the
〈ENTER/START〉 key.
If the Layer Thickness function (see page 2–13) is enabled, the
gauge prompts for the layer thickness:
Input Layer
Thickness
51 mm
Press <ENTER>
Enter a layer thickness from 25 to 102 mm (2.0 to 4.0 in.) and press
the 〈ENTER/START〉 key.
The gauge displays:
Make Project
XXX
Active?
<YES> or <NO>
To enable the new project, press the 〈YES〉 key. The gauge enables
the new project, displays a brief confirmation message, and returns
to the Project menu.
To Next Page
Loading...
