Model 2701-B 4–7
4. USING THE GAUGE
NOTE
If the gauge goes into sleep mode while in the continuous
measurement mode (see page 2–16), the display returns
to the Ready screen. To exit sleep mode and continue
taking measurements, press the 〈ENTER/START〉 key.
AVERAGING MODE
In averaging mode, the operator can take up to 30 measurements at
selected locations. The gauge then calculates the average of the
measurements. This mode enables the operator to determine the
average density over a larger area.
Extend the telescoping handle (see Figure 1–1) to reduce the
bending required while taking measurements.
To take a measurement in averaging mode, select the mode as
described on page 2–16.
To Next Page
Loading...
