5–8
STORING DATA
The Model 2701-B can store approximately 1000 readings. As
described in the previous section, the gauge stores readings under
the project name that has been enabled. For more information on
selecting a project, see page 5–2.
Project data can be output as described on page 5–5. When using the
Spreadsheet option, the gauge outputs the following information for
each reading:
♦ Project name
♦ Layer Thickness – This value is displayed only if the Layer
Thickness function is enabled.
♦ Record number
♦ Measurement time
♦ Measurement date
♦ Measurement mode
♦ Gmb (Marshall) – This value is 0.0 if the Gmb (Marshall) target
is 0.0.
♦ Gmm (Voidless) – This value is 0.0 if the Gmm (Voidless)
target is 0.0.
♦ Density measurement
♦ Low density – This value is 0.0 if not in segregation mode.
♦ High density – This value is 0.0 if not in segregation mode.
♦ Air voids – This value is 0.0 if Gmm (Voidless) target is 0.0.
♦ Slope
♦ Offset
♦ Gmb (Marshall) target
♦ Gmm (Voidless) target
♦ Mat temperature – This value is 0 if the Temperature option
(see page 2–10) is not installed.
♦ Station ID
♦ User ID
♦ Location (right or left) of centerline – This value is blank if not
in continuous mode.
♦ Distance from centerline – This value is 0.0 if not in continuous
mode.
To Next Page