Model 2701-B 3–1
3. ADJUSTING MEASUREMENTS
CHAPTER 3
ADJUSTING MEASUREMENTS
This chapter explains how to adjust gauge measurements using
density offsets and mix calibration (slope and intercept) values for a
particular material.
CONTENTS
Introduction................................................................................... 3–2
Offset ............................................................................................ 3–3
Determining the Density Offset ............................................. 3–3
Managing Density Offsets...................................................... 3–4
Mix Calibration............................................................................. 3–6
Enable a Mix Calibration ....................................................... 3–6
New Mix Calibration.............................................................. 3–7
Disable the Mix Calibration................................................. 3–10
To Next Page
Loading...
