Troxler PaveTracker Plus - Page 90

Index–2
Disable
Density offset ............................................................................3–4
Mix calibration ........................................................................3–10
Target ......................................................................................2–15
E
Electrical specifications................................................................C–3
Enable
Density offset ............................................................................3–4
Mix calibration ..........................................................................3–6
Target ......................................................................................2–14
Enter target ..................................................................................2–15
ENTER/START key......................................................................2–3
Erase projects ................................................................................5–5
ESC key.........................................................................................2–3
F
Format, project output...................................................................5–6
G
Gauge temperature, internal .........................................................A–3
I
Inspection ......................................................................................1–7
K
Keypad ..........................................................................................2–2
L
Layer thickness....................................................................2–13, 5–4
LIGHT key ............................................................................2–3, 2–5
M
Measurement
Mode........................................................................................2–16
Specifications ...........................................................................C–2
Mechanical specifications ............................................................C–4