TRUE ICE SERVICE MANUAL truemfg.com
TEC_TM_198 | REV. A | EN
P#857284
03/26/2024 Page 56 of 96
Maintenance & Cleaning
8. Wait for the ice machine to run through the PRE-CLEANING
sequence (FILL, PUMP, DRAIN, and HARVEST). If there is enough
water in the sump at the start of CLEAN, it will go through a
DRAIN sequence before FILL. The compressor will start during
the HARVEST sequence to ensure there is no ice on the
evaporator and will shut off before the cleaning sequence
continues.
9. When ADD SANITIZER appears, open the water curtain and
pour in 10 oz (296 mL) chlorine bleach (5.25% sodium
hypochlorite) between the evaporator and the damper.
10. After adding chlorine bleach (5.25% sodium hypochlorite),
press OK. The display will then show the sequence status.
NOTICE ›
The sequence will not proceed from this point
unless OK is pressed after adding chlorine bleach (5.25%
sodium hypochlorite).
11. When the sanitizing sequence finishes, the ice machine will
either go into STANDBY mode or return to MAKE ICE mode
based on the choice made in step 7.
To Next Page
Loading...
Need help?
General
