True ZTX 825 - Error and Service Codes

Section E
99
Calibration
Incline and Speed Calibration (Continued)
4. Remove and replace Safety Key to exit Calibration Mode
Error And Service Codes
The following Error Codes and Service Codes will follow a double “beep” and show on
the display. Service Codes provide preventive maintenance reminders. A Service Code will
repeat for the next five times you start the treadmill. A Service Code will clear after any
key has been pressed. When an Error Code occurs, call an authorized service technician.
The Error Codes display differently on the ZTX 825P/HRC than on the ZTX 825.
Error/Service Code Description
ZTX 825P/HRC ZTX 825 Description
E1: MINIMUM E1 _ Not Used
E1: RANGE E1 r This error occurs when the incline values on the display do
not match the values stored during calibration.
E1: STALL E1 S This error occurs when the incline motor does not move in
response to an incline command.
E1: INCLINE E1 i This error occurs when the incline motor moved without an
incline command.
E2: OVERSPEED E2 O This error occurs when acceleration exceeded design limits.
E2: CAL E2 C This error occurs when the speed displayed does not match
the stored value from calibration.
E2: RECAL E2 r This error occurs when a data error is detected at start up.
The Control Panel has reset to default values.
E3: EEPROM E3 E This error occurs when a data error is detected on the
EEPROM. Replace Control Panel circuit board.
E5: SENSOR E5 S This error occurs when no speed sensor data has been
detected at the Control Panel.
S1: LUBE S1 L This code occurs every 3460 miles to remind you to inspect
the autowaxer.
S2: CLEAN S2 C This code occurs every 500 miles to remind you to clean the
treadmill.