True ZTX 825 User Manual

Section E
100
Diagnostics
Your True ZTX treadmill is equipped with built in diagnostic capabilities to assist in
configuring, maintaining and servicing your treadmill. The Field Diagnostic mode provides
total hours, distance, average speed, ability to change the units of measure, ability to set
the “user not present” function, a list of service and error codes, the ability to set program
time, and a log of the last five errors.
NOTE:
Messages appear in the Message Center on the ZTX
825P and the ZTX 825HRC. The messages display
differently on the ZTX 825 and appear in the Primary
Display Window. They are shown below in parentheses.
1. Hold the while placing the Safety Key on the Keyboard.
The following messages will repeat themselves:
DIAGNOSTIC (diAg)
PRESS START
2. Press to display total hours.
The following messages will display:
HOURS (ttL) No. of hours on the treadmill
3. Press to display total distance.
The following messages will display:
DISTANCE (dIS) No. of miles on the treadmill
4. Press to display average speed.
The following messages will display:
AVG SPEED (ASP) Average speed on the treadmill
5. Press to display units. Press or to toggle.
The following messages will display:
UNITS ENG (Eng) or MET (H)
6. Press to display User Not Present function.
The following messages will display:
CURRENT SHUT (Crnt) No. of seconds until treadmill
shuts off with no user on tread belt
7. Press repeatedly to display list of errors.
The service/error codes will be listed. See Error and Service Codes on the
previous page.

True ZTX 825 Specifications

General

Brand	True
Model	ZTX 825
Category	Treadmill
Language	English