Section B
19
SAFETY KEY and Lanyard Clip
You can help to protect yourself from injuries resulting from unexpected loss of balance by
attaching the SAFETY KEY to the Keyboard and the lanyard clip to your clothing about
waist height. When the SAFETY KEY is detached from the Keyboard, your treadmill
stops, resets itself, and will not operate.
Quick Start/START/RESET Key
The Quick Start/START/RESET Key starts the belt in motion. It also resets distance, time,
and calories when held for three seconds. It can be used to start a manual mode workout
without having to go through any setup.
GRADE Keys
The GRADE Keys adjust the incline at any time during your workout.
STOP/PAUSE Key
The STOP/PAUSE Key stops the treadmill at any point in your workout. Information will
be retained for 30 seconds unless the STOP/PAUSE key is held for five seconds or longer.
SPEED Keys
The SPEED Keys are used to adjust the speed in .1 MPH increments and change weight.
SELECT/ENTER Key
The SELECT/ENTER Key is used to enter your weight. It is also used for selecting what is
displayed in the Primary Display Window. It can be used to alternate from scan mode to
hold on one display. To change from scan mode to hold on a specific display, press the
SELECT/ENTER Key when that indicator is blinking. The indicator will then remain lit. A
blinking indicator tells you the display is in scan mode and will rotate through all the
displays. It changes from one display to the next every 15 seconds.
ZTX 825 Keyboard
To Next Page
Loading...
