Tusa ELEMENT - To Set Units of Measure

22
• Press/release the button (less than 2 seconds) to toggle
between ON and OFF.
• Depress the button for 2 seconds to accept the Set Point and
advance to Set Units Of Measure.
TO SET - UNITS OF MEASURE
Factory set for Imperial, Units of can also be set for Metric.
• After having set and accepted Wet Activation, the Set Units
screen appears with the Set Point flashing (Fig. 19).
- - or - -
• While the Surface Sequence is scrolling, depress the button
for 6 seconds to bypass Set FO2 and Set Wet Activation,
then release the button.
• Press/release the button (less than 2 seconds) to toggle
between Metric (M and C) and Imperial (FT and F) units.
• Depress the button for 2 seconds to accept the Units Set Point
and advance to Set Hour Format.
Fig. 19 - SET UNITS OF
MEASURE