Tusa ELEMENT - To Set Time

24
TO SET - TIME
Set for factory local time, the Time can be set to values between
1:00 and 12:59 (AM/PM) or 0:00 and 23:59.
• After having set and accepted Hour Format, the Set Time
screen appears with the Hour Set Point flashing (Fig. 21).
- - or - -
• While the Surface Sequence is scrolling, press the button for
10 seconds to bypass Set FO2, Wet Activation, Units, and
Hour Format, then release the button.
• Press/release the button repeatedly (less than 2 seconds
each time) to advance the Hour Set Point in increments of 1
Hour per press of the button.
• Depress the button for 2 seconds to accept the Hour Set
Point, the Minutes Set Point flashes.
• Press/release the button repeatedly (less than 2 seconds
each time) to advance the Minute Set Point in increments of 1
Minute per press of the button.
• Depress the button for 2 seconds to accept the Minute Set
Point and advance to Set PO2 Alarm.
Fig. 21 - SET TIME