Page 32 of 56
6.2. Parameters
This directory enables the operator to watch and change the cycle’s
parameters. Therefore it is necessary to choose the required cycle
before entering the "MENU" directory (see "operating instructions").
For seeing or changing the parameters proceed as follows:
This CYCLE PARAMETERS screen is displayed when entering the
"PARAMETERS" directory:
The following parameters of the current cycle are displayed:
1. Ster Time: sterilization exposure time in minutes.
2. Dry Time: drying time in minutes.
To choose the required value, use the UP and DOWN keys. When the
required parameter is blinking press START/STOP.
The default time value is the minimum allowable value. It is possible to
increase the time value up to a maximum of 99 minutes.
1. To move the curser from one digit to another press the
START/STOP key.
2. Use the UP and DOWN keys to increase or decrease the current
digit.
3. After changing the parameter to the required value, confirm the
new value. Do this by pressing START/STOP a few times until
SET is blinking and then press UP or DOWN.
4. If, before confirmation you decided not to change the parameter,
press START/STOP a few times until EXIT is blinking. Press
UP or DOWN. The display will return to the previous menu.
5. If, by mistake, the curser skipped the SET and reached EXIT,
continue to press START/STOP until the curser returns to SET.
To Next Page
Loading...
