Page 33 of 56
6.3. Setting the Clock
This directory enables the operator to set the time and date.
This SET CLOCK screen is displayed when entering the directory:
When entering the SET CLOCK display, the time and date are
displayed. The curser is blinking on the "hour" digit.
The time is displayed in the upper row in the form “hh:mm:ss”. The
hour range is 24 hour (i.e. from “0” to “24”)
The date is displayed in the lower row in the form “DD:MM:YY”.
1. To increase or decrease the time or the date use the UP and
DOWN keys.
2. To move the curser from one digit to another press the
START/STOP key.
3. After changing the time and the date move the curser to “SAVE”.
4. Confirm the new time and date by pressing UP key. While the new
time and date are being saved the following screen is displayed:
5. After saving is completed, SET CLOCK screen is displayed move
the cursor to EXIT and press UP to return to MENU screen.
To Next Page
Loading...
