Page 47 of 83 Pages
6.5.3 Screen Saver
This subdirectory enables the operator to set the screen saver
time.
The default time value is 90 minutes. It is possible to increase
or decrease the time value up to a maximum of 600 minutes or
down to a minimum 0 minutes.
When entering the
Screen Saver screen, the time will be
displayed. The cursor is blinking on the "minute" digit.
The time is displayed in the form “0000” min.
1. To increase or decrease the digits, press the UP or DOWN
keys.
2. After changing the value move the cursor to Set by pressing
the START/STOP.
3. When Set is blinking, press the UP or DOWN keys in order
to confirm changes and return to the previous screen.
4. In order to exit this screen follows one of the next:
In order to exit this screen move the cursor to Exit with
the START/STOP key and select it by pressing the UP
or DOWN keys.
Press the UP and DOWN keys simultaneously.
To Next Page
Loading...
