Page 73 of 83 Pages
10.8 Stopping the process and cancelling the ERROR message
It is possible to stop the program while the autoclave is operating.
Pressing the
START/STOP key at any stage of the process stops the
operation. If the cycle was aborted before completing the sterilization
stage, it will leave the load unsterilized.
At the end of the aborted process (before completing the sterilization
stage),
"Cycle Failed" message, error message and a warning symbol
are displayed on the screen. Refer to "Displayed Error
Messages/Symbols".
Pressing the START/STOP key cancels the displayed message and
enables opening the door.
Warning
The load has not completed a sterilization cycle, therefore it is not
sterile. Handle it as contaminated load.
10.9 Start Cycle by Clock mode
This mode enables the operator to define the time of the beginning of
the cycle. The maximum possible delay is 24 hours. For further
information see sec. 6.8.1. “Start Cycle by Clock”.
10.10 Moving the Autoclave
1. Disconnect the power supply cord.
2. Disconnect the water and drain hoses.
3. Disconnect the compressed air hoses (if applicable).
4. Drain the water from the chamber.
To avoid injuries, Moving the autoclave should be done by using a
forklift.
Caution:
Before moving the autoclave, verify that the electrical, air and water
connections have been disconnected, and there is no pressure in the
chamber.
Do not drop this device!
10.11 Loading and Unloading the Device
10.11.1 Safety
Protective equipment and clothes and other safety instructions
should be implemented in accordance with local and national
regulations and/or rules!
For proper sterilization - Do not overload the chamber. Only
autoclavable products shall be used; please refer to the
manufacturer instructions for sterilization of unknown materials
or instruments.
To Next Page
Loading...
