Tuttnauer ELV-D - Starting, Closing Door, and Unloading

Page 72 of 83 Pages
10.3 Loading
 Load the autoclave properly according to instructions in sec. 9.
 Select the program.
 UP key: next program.
 DOWN key: previous program.
 Verify that you chose the required program.
10.4 Selecting program
 Select the required program
 UP key: next program
 DOWN key: previous program
 Verify that you chose the required cycle.
Attention:
Selecting a program is possible only when the door is open.
10.5 Closing the door
 Close the door.
 Move the door handle (1) from position "unlocked" (3) to position
"locked" (2).
 The open door symbol is replaced by the message "System
Ready".
10.6 Starting cycle
 Start the cycle by pressing the START/STOP key.
10.7 Unloading
When the cycle ended successfully (including pressing the
START/STOP key, or any failure, after completing the sterilization
stage) message "Cycle Ended" (and the relevant failure message, if
applicable) is displayed on the screen.
 Verify that there is no pressure in the chamber, according to the
reading on the display. Only than you may open the door.
 Open the autoclave. (see sec. 10.2 Opening the door)
Warning
To avoid sever injuries from hot steam when opening the door:
 It is strictly forbidden to lean on the autoclave.
 It is strictly forbidden to place your hand or any part of your
body over the door.
 Wear heat-resistant gloves or use the tray handle to remove the load
from the autoclave
 On completion of the cycle, the load shall be visual inspected to
ascertain that the load is dry, and that the colour of the sterilization
indicators turned to the required colour.