Page 39 of 83 Pages
6.4 Cycle Parameters (Custom 1)
This directory applicable only for custom 1 and custom 2 programs
Subdirectory Property
Create Pulse
Pulse A Count
Pulse A Stay Time
Pulse A Low Pressure
Pulse A High Pressure
Pulse B Count
Pulse B Stay Time
Pulse B Low Pressure
Pulse B High Pressure
Heat Sterilization Temperature
Sterilization
Sterilization Temperature
Sterilization Time
F0 Mode
Cooling
Cool mode
Cool End Temperature
Cool Exhaust Rate
Exhaust Exhaust Mode
Dry
Dry Heat On 1
Dry Heat Off 1
Dry first stage time
Dry Heat On 2
Dry Heat Off 2
End
End Temperature
Multiple Cycles
Multiple Cycles Gap
This directory includes seven subdirectories
These subdirectories enable to see and change the cycle parameters.
Therefore it is necessary to choose the required cycle before entering the
"
MAIN MENU".
For seeing or changing the parameters proceed as follows:
Choose and enter
cycle parameters
The following screen will display:
To Next Page
Loading...
