30
Setting Up Your Scanner
Before installing batteries, set the switch in the battery
compartment to match the type of batteries you will use.
Select ALKALINE for non-rechargeable battery types
and RECHARGEABLE for rechargeable battery types.
See also “Using Rechargeable Batteries” on Page 31
when you use rechargeable batteries.
1. Remove the battery cover and set the battery switch.
2. Install 2 AA batteries, matching the polarity symbols
(+ -).
WARNING!
Set ALKALINE/RECHARGEABLE to RECHARGE-
ABLE for use only rechargeable batteries. Never
attempt to recharge non-rechargeable batteries. Non-
rechargeable batteries can get hot or burst if you try to
recharge them.
To Next Page
Loading...
