42
Basic Operation
1. Press to hold on the system (or hold and
rotate the scroll control to select the system).
2. Continue to hold and press the number key
corresponding to the channel group you want to
activate or deactivate.
Locking/Unlocking Systems
Follow these steps to lock out a system so that it does not
scan even if its quick key is selected.
1. While holding down , rotate the scroll control to
select the system.
2. Continue to hold down and press L/O to lock
out the system.
3. Repeat Steps 1 and 2 to unlock a system you have
previously locked.
Locking/Unlocking Channels
Follow these steps to lock out a channel so that it does
not scan even if its system and channel group are
selected.
1. While holding down , rotate the scroll control to
select the system where the channel is stored.
2. Release then press Hold within 2 seconds to
hold on the system.
3. Rotate the scroll control to select the channel you
want to lock or unlock.
4. Press L/O to lock or unlock the channel.
You can also lock out an active channel by pressing L/O
while the scanner is stopped on the channel.
ID Scan/ID Search Mode
While you are scanning a trunked system, the scanner
can be in either ID Scan or ID Search mode:
Func Func
Func
Func
Func
Func
Func
To Next Page
Loading...
