59
Programming Radio Systems
Input a system frequency, then press E. The scanner then
prompts you to enter the LCN for the entered
frequency. Enter the LCN, then press E.
To enter additional frequencies, press , use the scroll
control to select New Frequency, then repeat the above.
Entering/Editing LTR Channel Groups
To enter channels in a system, first set up a channel
group (or groups) to hold the channels. Then, enter the
channel and channel parameters in the group(s).
Setting Up a Channel Group
EDIT GROUP E
NEW GROUP E
The scanner creates a group with a default name of
GROUP nn. nn increments by one for each new group you
create within a system.
Next, refer to the appropriate section to set group-wide
options:
• See “Entering/Editing the Group Name” on Page 70
• See “Setting the Group Quick Key” on Page 70
• See “Setting Channel Lockout” on Page 76
• See “Deleting Groups” on Page 71
• See “Copying/Pasting Systems” on Page 69
• See “Entering/Editing LTR Channels” on Page 59
Entering/Editing LTR Channels
Edit Channel E
NEW Channel E
Input TGID
Enter the talk group ID for the channel, then press E.
Note: Press No to enter a hyphen.
Menu
To Next Page
Loading...
Need help?
General
