80
Searching
Editing a Custom Search Range
You can edit up to 10 custom search ranges. The names
of the custom search ranges appear on the display. The
default custom search range names appear as CUSTOM 1,
CUSTOM 2, and so on.
1. Press then turn the scroll control until
Search For ... appears. Then press E. Or press
and Srch, then No. One of the search feature options
appear.
2. Turn the scroll control until EDIT CUSTOM appears,
then press E to select it.
3. Turn the scroll control until the name of the custom
search range you want to edit appears, then press E
to select it. The following options appear as you turn
the scroll control.
EDIT NAME - lets you edit the custom search range’s
name
EDIT SRCH LIMIT - lets you view and select the
frequency ranges to search. The scanner prompts
you to enter the upper and lower search limits.
SET DELAY TIME - lets you set the amount of time the
scanner will delay before continuing to search after a
transmission ends
SET MODULATION - lets you set the custom search
range’s modulation type
SET ATTENUATOR - lets you set whether the scanner
will attenuate reception by 18dB during search
SET DATA SKIP - lets you set whether the scanner will
skip data transmissions during search
SET STEP - lets you set the custom search range’s
step (the gap between frequencies)
4. Select the option you want to change for the custom
search range you selected, then press .
Menu
Func
E
To Next Page
Loading...
Need help?
General
