54
Programming Radio Systems
Setting Up a Channel Group
Edit Group E New Group E
The scanner creates a group with a default name of
Group nn. nn increments by one for each new group you
create within a system.
Next, refer to the appropriate section to set group-wide
options:
• See “Entering/Editing the Group Name” on Page 70
• See “Setting the Group Quick Key” on Page 70
• See “Deleting Groups” on Page 71
• See “Copying/Pasting Systems” on Page 69
• See “Entering/Editing Motorola Channels” on
Page 54
Entering/Editing Motorola Channels
Edit Channel E
New Channel E Input TGID
Enter the Talk Group ID for the channel, then press E.
Notes:
• Motorola Type 2 Talk Group ID's are entered as
5-digit numbers.
• Motorola Type I Talk Group ID's are entered as two
numbers separated by a hyphen. Use the decimal
point to enter the hyphen.
• To enter an I-Call ID, press , then enter the ID. The
displays as i when entering the ID, but as 7 when
it is active on a Type 2 system.
Then, refer to the appropriate section to change a
channel setting:
• See “Editing the Channel Name” on Page 71
• See “Setting Emergency Alert (Motorola and EDACS
Systems Only)” on Page 67
To Next Page
Loading...
