Uniden BC246T - System Timing and Delay Settings; Setting the System Hold Time; Setting the Channel Delay Time

63
Programming/Editing Optional Settings
Setting the System Hold Time
 Program SysteMS  E 
Select the system  E 
Edit Sys Option  E 
Set Hold Time E
This setting controls how many seconds the scanner
scans a system before moving to the next unlocked
system. Enter a value from 0-255, then press E to save
the setting.
Notes:
• If you select 0, the scanner stays on the system for a
minimal time (only long enough to check current
system activity).
• The default setting is 2 seconds for each system.
• For conventional systems, all channels will be
scanned at least one time regardless of this setting.
• The scanner moves to the next system after the hold
time expires, any current transmission ends, and the
channel delay time expires.
Setting the Channel Delay Time
 Program SysteMS  E 
Select the system  E 
Edit Sys Option  E 
Set DELAY Time E
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Enter a value from 1-5 or Off, then press E.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the system.
Menu
Menu