79
Searching
Searching
Custom Search
Custom Search lets you program and search 10 custom
search ranges. You can search any of these ranges
simultaneously and select each custom search range you
set. During custom search, the scanner searches starting
with the lowest frequency in the search range you select
to the highest frequency in the range.
Notes:
• Search ranges are preset. See “Editing a Custom
Search Range” on Page 80 to change the range.
• You cannot turn off all custom search ranges.
1. Press then turn the scroll control until Search
For ... appears. Then press E. Or, press + Src,
then select No. One of the search feature options
appear.
2. Turn the scroll control until CUSTOM Search appears,
then press E to select it. The scanner starts custom
search of the custom search range you selected,
stopping on any transmission it finds and displaying
the frequency. Turn the scroll control to change the
search direction. An arrow appears, showing the
current search direction.
To turn search ranges on or off, press 0 and 1-9.
To hold searching, press Hold. To resume searching,
press then press Scan/Srch or Hold again.
To lock out a frequency found while searching, press
L/O. Search Lockout? appears. Press E to lock out
the frequency or No to continue monitoring.
If you turn off the active custom search range, the
scanner skips to the next custom search range and
continues searching.
Note: If all frequencies in all active custom search
ranges are locked out, All Locked! appears and the
scanner does not search.
Menu
Func
Func
Searching
To Next Page
Loading...
Need help?
General
