Uniden BC246T - Motorola System Frequency Configuration; Setting System Frequencies; Entering Motorola Channel Groups

53
Programming Radio Systems
• See “Setting Control-Channel Only (Motorola Sys-
tems Only)” on Page 68
• See “Setting System Lockout” on Page 62
• See “Reviewing Locked Out Frequencies” on
Page 86
• See “Setting System Attenuation (Trunked Systems
Only)” on Page 68
• See “Deleting Systems” on Page 69
• See “Copying/Pasting Systems” on Page 69
• See “Setting System Frequencies” on Page 53
• See “Entering/Editing Motorola Channel Groups”
on Page 53
Setting System Frequencies
SET FREQUENCIES  E
 New FREQUENCY  E
Input a system frequency, then press E.
To enter additional frequencies, press , use the scroll
control to select New Frequency, then repeat the above.
Note: If you select Control Channel Only mode (see “Set-
ting Control-Channel Only (Motorola Systems Only)” on
Page 68), you only need to enter the frequency(s) that
can be assigned as the control channel (this is usually
notated on the available frequency lists). Otherwise, you
must enter all of the frequencies.
Entering/Editing
Motorola Channel Groups
To enter channels in a system, first set up a channel
group (or groups) to hold the channels. Then, enter the
channel and channel parameters in the group(s).
Menu