57
Programming Radio Systems
The scanner creates a group with a default name of
GROUP nn. nn increments by one for each new group you
create within a system.
Next, refer to the appropriate section to set group-wide
options:
• See “Entering/Editing the Group Name” on Page 70
• See “Setting the Group Quick Key” on Page 70
• See “Deleting Groups” on Page 71
• See“Editing the Channel Name” on Page 71
Entering/Editing EDACS Channels
Edit Channel E
NEW Channel E Input TGID
Enter the Talk Group ID for the channel, then press E.
Notes:
• If you have selected to use AFS format for Talk Group
ID's (the default), use the decimal point to enter the
hyphens.
• To enter an I-Call ID, press , then enter the ID.
• If you omit the fleet and/or subfleet, the scanner
treats these fields as wildcards.
Then, refer to the appropriate section to change a
channel setting:
• See “Editing the Channel Name” on Page 71
• See “Setting Channel Alert” on Page 73
• See “Setting Channel Lockout” on Page 76
• See “Deleting Channels” on Page 77
• See “Copying/Pasting Channels” on Page 77
To program another channel within the same group, press
, then repeat the above. To create another channel
group and enter more channels, press twice, then
proceed from “Entering/Editing EDACS Channel Groups”
on Page 56.
Menu
Menu
To Next Page
Loading...
Need help?
General
