182 Video function
Self view
Prerequisite: The phone is in idle mode.
In order to test whether your USB camera is working properly, activate the Self
view function in the context menu (see also
Page 32).
Select and confirm the option shown in the context menu. You will see a video
image of yourself and your surroundings on the display for approx. 10 seconds.
Video link
If the video function on your OpenScape Desk Phone IP 55G and the selected
remote station – likewise a OpenScape Desk Phone IP 55G – is enabled, you
can see your call partner and your call partner can see you on the display when
the connection has been set up (see
Page 32).
^ Lift the handset.
j Enter the phone number.
In the pop-up menu:
Select the softkey to confirm or wait until the dial delay expires (see
Page 118).
or
Select the softkey to confirm
1
.
The video link is set up automatically. The video image of your call partner ap-
pears.
Consultation
You can call a second partner during a video link.
Confirm with the softkey for the connection.
The connection to the video caller is placed on hold and the video image is hid-
den.
j Enter and confirm the second party's phone number.
Toggle/Connect
For a detailed description of alternating (toggling), see Page 70.
Select the softkey to confirm.
Switch to the first and then back to the second party so that the current picture
of the call partner is displayed in each case.
If you connect your two call partners (see Page 72), they will likewise have a
video link.
In the absence of a USB camera
If one of the partners has enabled his or her video function but does not have a
USB camera connected, you will see a crossed-out camera instead of the video
image of the call partner.
1. Please note the information in relation to the call journal on Page 65
To Next Page
Loading...
