Unify OpenScape Desk Phone IP 55G - Lines with Hot or Warm Line Function; Connecting

Making calls with multiple lines 129
Lines with hot or warm line function
Your administrator can configure a hot or warm line for the primary and second-
ary line.
The function is activated when on
• the primary line
you lift the phone's handset or press the line or loudspeaker key
• the secondary line
you press the line key.
A number specified by you is dialled immediately with a hot line and after a spe-
cific time with a warm line.
Examples:
• The phone in the lift immediately dials the reception number.
• The phone at a patient's bed dials the ward number after one minute, for ex-
ample, if no other number is dialled.
Entering a number for the hot and warm line function
Specify which number should be dialled when the hot or warm line function is
activated.
z
You can also configure this setting via the WBM interface  Page 247.
Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the required line in the context menu.
Select and confirm the option shown.
j Enter and confirm the destination.
Select the softkey to confirm.
Connecting
A station of a line trunk group is on a call. Its primary line is configured as a sec-
ondary line on your phone. This line now has the status "busy." You can connect
to the call by pressing the illuminated key for this line (see also
 Page 25).
Prerequisite: A secondary line is set up on your multi-line phone, the option to
connect to the call is activated for your phone and "system conference" is set up
for your system (
 Page 123).
If a preview is set up and activated for the relevant line ( Page 152), you have
to press the line key a second time following the preview in order to connect.
Services
User
Configuration
Keyset
Lines
Line
Hot warm dest
Save & Exit