184 OpenScape Voice functions
OpenScape Voice functions
The OpenScape Voice supports a number of functions that you can activate and
deactivate from your phone.
Feature toggle key for hunt group
You can pick a programmable function key and program it as a feature toggle
key for activating the "make line busy" and "stop hunt" functions.
You can then use the programmable function key to activate or deactivate the
relevant OpenScape
Voice function on the server for this phone.
You can only program first-level programmable function keys because those
linked to LEDs are used to display the function status as either on (LED on) or
off (LED off). The LED indicates the status of the function on the server and can
therefore change without any of the programmable function keys being pressed.
Example:
Switching between "Line busy" and "Line free" (see also Page 190).
Prerequisite: Your administrator configured a programmable function key with
the function "Busy" ("make line busy" for the hunt group)
Page 94.
Press the programmable function key – the key lights up.
Press the illuminated programmable function key once again to release the line
- the keys stops illuminating.
Some OpenScape Voice functions are only available if the "Server fea-
tures" function was activated on the phone by the administrator.
On multi-line telephones, the full scope of OpenScape Voice functions is
only available for the primary line.
Hunt group functions can also be activated via codes Page 190.
To Next Page
Loading...
