3-2
Sectio
n
3.1 Safety Rules and Precautions
Before using the TL33 Work Platform:
NEVER operate the machine unless you have been fully
trained in its safe use, are medically fit and have read
and fully understood these instructions.
NEVER LEAVE A LIFT UNATTENDED WITH THE
PLATFORM IN THE RAISED POSITION.
ALWAYS position the machine on firm level ground with
a minimum bearing capacity of 550KN/m
2
.
CHECK that no overhead obstructions exist within the
machines range of movement. DO NOT work within 8
metres of live overhead cables. Set up warning tape
barrier at the safe distance.( THIS MACHINE IS NOT
INSULATED).
DO NOT operate unless all four outriggers are fully
lowered, locked and screwed down to ground level taking
the load of the machine.
DO NOT exceed the safe working load of 215kg
(max. 2 persons plus 55kg equipment)
NEVER sit, stand or climb on guard rail or midrail.
NEVER use ladders or scaffolding on the platform.
DO NOT use the machine as a crane or for any other
application involving additional loads or forces. The
maximim side force must not exceed 400N.
DO NOT increase wind loadings by fitting items such as
sign boards, flags etc. to the cage or boom.
DISTRIBUTE all loads evenly on the platform. See Table
1-1 for maximum platform load.
NEVER use damaged equipment. (Contact UpRight
Ireland Ltd. for instructions).
NEVER attach overhanging loads or increase the size of
the working platform.
DO NOT use in winds exceeding 12.5m/s (27mph -
Beaufort Force 6)
NEVER change or modify operating or safety systems.
INSPECT the machine thoroughly for cracked welds,
loose hardware, hydraulic leaks, damaged control cable,
loose wire connections and wheel bolts.
NEVER climb down an elevating assembly with platform
elevated.
NEVER perform service on or in the elevating assembly
while the platform is elevated without first blocking the
elevating assembly.
NEVER recharge batteries near sparks or open flame;
batteries that are being charged emit highly explosive
hydrogen gas.
SECURE the work platform against unauthorised use by
turning keyswitch off and removing key from switch.
NEVER replace any component or part with anything
other than original replacement parts without
manufacturer’s consent.
To Next Page
Loading...
Need help?
General
