What if...
66
Troubleshooting
• Press the "ESC/INFO" key to view Error 81.
Press the "ESC/INFO" key again to reset
the message.
• Clean pump.
• Repair cable damage or cable break.
• Press the "ESC/INFO" key to view Error 82/
83. Press the "ESC/INFO" key again to
reset the message.
• If this message appears frequently, call
Customer Service.
Fault description
The pump is consuming too much power and
the control output for the pump is shut off.
Reset the error. After the reset the pump can
be controlled again.
There could be two reasons for the high power
consumption:
• Sluggish pump due to dirt accumulation
or
• Cable damage or cable break in the cable to
the pump
Circuit board for portion dispensing control: too
much power is being diverted over the
switching output 2 or 3.
Display message
81 Fault
Pump???
82 Fault
83 Fault
No.
Type
81
1
82
1
83
1
To Next Page
Loading...
Need help?
General