US Robotics Courier V.Everything - Using DIP Switches to Configure Your Courier

DIP Switches and Jumpers 7-3
Using DIP Switches to Configure Your Courier
To do this Set DIP
Switch
To this setting
Set DTR to Normal 1 OFF (Default)
Ignore DTR ON
Set verbal result code display 2 OFF (Default)
Set numeric result code display ON
Disable result codes 3 OFF
Enable result codes ON (Default)
Enable the echo in offline commands 4 OFF (Default)
Disable the echo in offline commands ON
Enable auto answer 5 OFF
Disable auto answer ON (Default)
Enable normal Carrier Detect 6 OFF (Default)
Disable normal Carrier Detect ON
Display result codes In ALL modes 7 OFF (Default)
Display result codes in orginate mode only ON
Disable AT commands 8 OFF
Enable AT commands ON (Default)
Disconnect on escape (+++) 9 OFF (Default)
Don’t disconnect on escape (+++) ON
Load the configuration that is stored in non-
volatile memory (NVRAM)
10 OFF (Default)
Load the &F0 configuration from read-only
memory (ROM)
ON