10-19
Troubleshooting > Responding to Error Messages
W
Responding to Send Error
Error Message Checkpoints Corrective Actions Reference
Page
Warning low memory. ā Job cannot be started. Try again later. ā
Code Error Corrective Actions Reference
Page
1101 Failed to send the e-mail. Check the host name of the SMTP server on the Embedded Web
Server RX.
2-34
Failed to send via FTP. Check the host name of FTP. 6-20
Failed to send via SMB. Check the host name of SMB. 6-20
1102 Failed to send via SMB. Check the SMB settings.
⢠Login user name and login password
NOTE: If the sender is a domain user, specify the domain
name.
⢠Host name
ā¢Path
6-20
Failed to send the e-mail. Check the followings on the Embedded Web Server RX.
⢠SMTP login user name and login password
⢠POP3 login user name and login password
2-34
Failed to send via FTP. Check the FTP settings.
⢠Login user name and login password
NOTE: If the sender is a domain user, specify the domain
name.
ā¢Path
⢠Folder share permissions of the recipient
6-20
1103 Failed to send via SMB. Check the SMB settings.
⢠Login user name and login password
NOTE: If the sender is a domain user, specify the domain
name.
ā¢Path
⢠Folder share permissions of the recipient
6-20
Failed to send via FTP. Check the FTP settings.
ā¢Path
⢠Folder share permissions of the recipient
6-20
1104 Failed to send the e-mail. Check the e-mail address.
NOTE: If the address is rejected by the domain, you cannot
send the e-mail.
6-17
1105 Failed to send via SMB.
Select [On] of the SMB settings on the Embedded Web Server RX.
2-32
Failed to send the e-mail.
Select [On] of the SMTP settings on the Embedded Web Server RX.
Failed to send via FTP.
Select [On] of the FTP settings on the Embedded Web Server RX.
1106 Failed to send the e-mail. Check the sender address of SMTP on the Embedded Web
Server RX.
2-34
1131 Failed to send via FTP. Select [On] of the secure protocol settings on the Embedded Web
Server RX.
2-32