To use a paper size that does not appear on the size dial, set the size dial to "Other". The
paper size must also be set from the operation panel. For details, see Quick Setup Wizard
on page 3-29.
Load the paper with the print side facing up.
Before loading the paper, be sure that it is not curled or folded. Paper that is curled or
folded may cause paper jams.
Ensure that the loaded paper does not exceed the level indicator (see the figure).
When loading the paper, keep the side that was closest the package seal facing up.
The paper length and width guides must be adjusted to the paper size. Loading the
paper without adjusting these guides may cause skewed feeding and paper jams.
Be sure that the paper length and width guides rest securely against the paper. If
there is a gap, readjust the guides to fit the paper.
To Next Page
Loading...
Need help?
General
