Job Accounting
ADVANCED OPERATION GUIDE 4-3
Access the Job Accounting Screen
Use the following procedure to display the Job Accounting screen.
1
Press [System Menu / Counter].
2
Press S or T to select Job
Accounting and press [Enter].
3
Use the keypad to enter the 4 digit
management code.
NOTE: The factory default management code varies for each model:
16 ppm model = 1600, 20 ppm model = 2000, and 25 ppm model = 2500.
The four-digit management code can be changed. For further information
refer to Administrator Management Code Change, on page 3-25.
If the code is accepted, the Job
Accounting screen displays.
4
Setup the options required using the instructions starting on page 4-4.
Counter Check
Print Report
System Menu / Counter:
Job Accounting
Enter Pin Code using # key.
Each Job Accounting TL
Job Accounting:
End
Job Accounting Total
[]On
To Next Page
Loading...
