Printer Settings
ADVANCED OPERATION GUIDE 2-11
Interface
This machine is equipped with a parallel, USB and network interface as
standard.
The following settings are available:
• Parallel Interface
• Network Setting
• IP Address Setting
• Subnet Mask Setting
• Default Gateway
• Network Status Page Printing
Access the Interface Screen
1
Press [Printer].
2
Press S or T to select MENU
and press [Enter].
3
Press S or T to select Interface
and press [Enter].
Setup the options required.
Parallel Interface
The parallel interface supports bi-directional/high-speed mode. The
transmission/reception modes that can be set are shown below.
GO
CANCEL
Ready
MENU
Back
Print Status Page
Menu
Interface
Mode Description
Auto The printer automatically changes its communication mode
according to the connected computer. We recommend you
leave this setting unchanged.
Normal The printer uses the standard communication method
prescribed for Centronics interfaces.
High speed This mode enables faster data transmission between the
printer and the computer. Select this mode if printing
problems occur when the printer is connected to a
workstation.
To Next Page
Loading...
Need help?
General
