Chapter 7: ECG
VS2000 Vital Signs Monitor Operation Manual 7-11
a) Push and Turn the rotary knob on the monitor to move the cursor. Highlight
the HR parameter box and push the knob to access the HR parameter menu.
b) Highlight ST ALARM and push the knob to select.
c) Choose the source of ST section from lead I, II, III, aVR, aVL, aVF, V.
d) Choose ON or OFF and push the knob to select.
e) Turn the rotary knob to “OK” or “Cancel” to save or delete your settings.
2. Set High and Low Alarm Limits
a) Push and Turn the rotary knob on the monitor to move the cursor. Highlight
the HR parameter box and push the knob to access the HR parameter menu.
b) Highlight ST ALARM and push the knob to select.
c) Move the cursor to High/Low and push the knob to select.
d) Turn the knob to increase or decrease the number and push it to confirm.
e) Turn the rotary knob to “OK” or “Cancel” to save or delete your settings.
3. Choose Alarm Priority
a) Push and Turn the rotary knob on the monitor to move the cursor. Highlight
the HR parameter box and push the knob to access the HR parameter menu.
b) Highlight ST ALARM and push the knob to select.
c) Choose Senior, Junior or Medium and push the knob to select.
d) Turn the rotary knob to “OK” or “Cancel” to save or delete your settings.
To Next Page
Loading...
