EasyManuals Logo

UTECH VS2000 User Manual

UTECH VS2000
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
Chapter 7: ECG
7-10 VS2000 Vital Signs Monitor Operation Manual
1. Push and turn the rotary knob on the monitor to move the cursor. Highlight
the HR parameter box and push the knob to access the HR parameter menu.
2. Highlight the ST switch and push the knob to select.
3. Choose AUTO or OFF and push the rotary knob to select.
4. Turn the rotary knob to “OK” or “Cancel” to save or delete your settings.
7.1.2 ST Display
The ST section will be displayed in the HR parameter box after you turn on the
ST switch.
Figure 7.10: ST Display
7.1.3 ST Alarm Setup
Figure 7.11: ST Alarm Setup
1. Turn Alarm Detection On or Off
You can turn on or off the alarm detection capability for the heart rate value.
If ST ALARMS is on, an alarm will be issued when the high or low alarm limit is
violated. If you turn ST ALARMS off and the high or low alarm limit is violated,
an alarm will not be issued. When you turn off the monitor and turn it on
again, ST ALARMS will be reset to ON; the default setting is ON.
To turn on or off the ST alarm detection:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UTECH VS2000 and is the answer not in the manual?

UTECH VS2000 Specifications

General IconGeneral
BrandUTECH
ModelVS2000
CategoryMonitor
LanguageEnglish

Related product manuals