78 • vacon parameter descriptions
Tel. +358 (0)201 2121 • Fax +358 (0)201 212205
9
4.11 STOP DC CURRENT FREQUENCY
It is the output frequency at which the DC-braking is applied.
4.12 START DC CURRENT TIME
DC-brake is activated when the start command is given. This parameter de-
fines the time of the DC-braking. After the brake is released, the output fre-
quency increases according to the set start function by par. 2.2.
t
Pa r4.12
Par 4.9
RUN
STOP
Output
frequency
DC-braking
current
Figure 9.10: DC braking time at start
To Next Page
Loading...
