vacon • 43 Parameter description
3
P5.8 EXTERNAL FAULT, CLOSE
Fault is triggered by high signal.
P5.9 E
XTERNAL FAULT, OPEN
Fault is triggered by low signal.
P5.10 R
UN ENABLE
Motor stops by coasting if the signal is missing.
Note: The drive is not in Ready state when Enable is low.
P5.11 R
AMP TIME 2 SELECTION
Ramp 2 is selected by signal high.
P5.12 MOTOR POTENTIOMETER UP
Signal high causes speed increase.
P5.13 M
OTOR POTENTIOMETER DOWN
Signal high causes speed reduction.
P5.14 Q
UICK STOP OPEN
Signal low forces the drive to stop, ramping down with the time defined in P4.9.
To see description of P2.5 for details about the function.
P5.15 Q
UICK STOP CLOSE
Similar to P5.14, but in this case Quick Stop is activated by high signal.
To Next Page
Loading...
