Vaisala CL31 - Page 68

USER'S GUIDE____________________________________________________________________
66 __________________________________________________________________ M210482EN-D
b41 (0200 0000 0000) Light path obstruction (A)
b40 (0100 0000 0000) Receiver saturation (A)
D: b39 (0080 0000 0000) (spare) (A)
b38 (0040 0000 0000) (spare) (A)
b37 (0020 0000 0000) (spare) (A)
b36 (0010 0000 0000) (spare) (A)
C: b35 (0008 0000 0000) (spare) (A)
b34 (0004 0000 0000) (spare) (A)
b33 (0002 0000 0000) Coaxial cable failure (A)
b32 (0001 0000 0000) Ceilometer engine board failure (A)
B: b31 (0000 8000 0000) Window contamination (W)
b30 (0000 4000 0000) Battery voltage low (W)
b29 (0000 2000 0000) Transmitter expires (W)
b28 (0000 1000 0000) High humidity (W)
A: b27 (0000 0800 0000) (spare) (W)
b26 (0000 0400 0000) Blower failure (W)
b25 (0000 0200 0000) (spare) (W)
b24 (0000 0100 0000) Humidity sensor failure (W)
9: b23 (0000 0080 0000) Heater fault (W)
b22 (0000 0040 0000) High background radiance (W)
b21 (0000 0020 0000) Ceilometer engine board failure (W)
b20 (0000 0010 0000) Battery failure (W)
8: b19 (0000 0008 0000) Laser monitor failure (W)
b18 (0000 0004 0000) Receiver warning (W)
b17 (0000 0002 0000) Tilt angle > 45 degrees warning (W)
b16 (0000 0001 0000) (spare) (W)
7 b15 (0000 0000 8000) Blower is on (S)
b14 (0000 0000 4000) Blower heater is on (S)
b13 (0000 0000 2000) Internal heater is on (S)
b12 (0000 0000 1000) Working from battery (S)
6 b11 (0000 0000 0800) Standby mode is on (S)
b10 (0000 0000 0400) Self test in progress (S)
b09 (0000 0000 0200) Manual data acquisition settings are
effective (S)
b08 (0000 0000 0100) (spare) (S)
5 b07 (0000 0000 0080) Units are meters if on, else feet (S)
b06 (0000 0000 0040) Manual blower control (S)
b05 (0000 0000 0020) Polling mode is on (S)
b04 (0000 0000 0010) (spare) (S)
4 b03 (0000 0000 0008) (spare) (S)
b02 (0000 0000 0004) (spare) (S)
b01 (0000 0000 0002) (spare) (S)
b00 (0000 0000 0001) (spare) (S)