USER'S GUIDE____________________________________________________________________
26 __________________________________________________________________ M010117EN-H
0408-011
Figure 14 Sounding Start Mode Selection
Select the sounding start mode by selecting the appropriate check
box(es):
- Automatic: DigiCORA detects the launch automatically from the
change in the measured pressure.
- Manual: The launch is keyed in at the launch time. With RT20A,
check Manual and start the sounding by clicking Manual Start on
the hand terminal.
- Both Automatic and Manual: If a manual launch is not keyed in, the
system uses its detection mechanism to start the sounding.
- Remote: You can use this option if you have a remote control
connected to UPP210. Sounding is then started by connecting pins 1
and 9 of SER IO connector on UPP210 momentarily.
Click Next to continue.
To Next Page
Loading...
