Chapter 3 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 27
Steps 9 and 10: Tuning the Receiver and
Setting RT20A in AUTO Tracking Mode
NOTE
Tuning the receiver is for RS80-67 only.
The receiver can be tuned either with the sounding workstation or the
Hand Terminal RTH21. Usually the receiver is automatically tuned with
the sounding workstation, but if you need to tune the receiver manually
just before the launch, the hand terminal can be useful. Instructions are
given in Chapter Hand Terminal RTH21 on page 41.
When the calibration coefficients have been accepted and the receiver is
tuned on the radiosonde signal band, the RT Radio Control view opens
within a few seconds (see Error! Reference source not found.).
0203-083
Figure 15 RT Radio Control View
If the view does not appear automatically, click the Radio miniview icon
in the Task Miniview pane on the left.
To Next Page
Loading...
Need help?
General
