When there is contact, the system runs a test, and
warning lamps (2), (3), (4), and (5) come on for a
short time.
If the warning lamps do not come on, examine the
protection fuse.
GUID-F1CD0FE3-7EBB-4D68-A581-E1FC651FA420-low.png [Low]
Fig. 153
When the engine temperature is too low, warning
lamp (A) comes on.
Let the lamp go o before you turn the key to start
position.
Release the key when the engine starts.
GUID-F70CBAF2-3F1E-4B7B-93D0-14CA4277DBEF-low.png [Low]
Fig. 154
IMPORTANT:
Operate the engine for approximately 10 minutes before you use the machine.
IMPORTANT:
Do not operate the starter motor for more than 30 seconds.
If the engine does not easily start, wait for 3 minutes, and then try again.
Do this sequence for a maximum of 3 times, and if the problem continues, speak to your dealer.
Moving the machine
IMPORTANT:
Do not use the hand throttle when you drive the machine on roads.
NOTE:
Set the hand throttle to the idle speed position (approximately 1200 rpm) for 2 - 3 minutes before you apply
heavy loads to the engine.
3. Operation
F Series 131
39940211 (555124)
To Next Page
Loading...
