Valtra F Series

4.3 Bulb replacement - Safety Instructions
When replacing a bulb, always comply with the following safety instructions:
CAUTION:
Always switch the lights o before you change a
bulb.
CAUTION:
First allow the bulb to cool down (it may cause burns).
CAUTION:
Wear safety goggles and gloves when changing the bulb.
CAUTION:
The bulb is made of glass and contains gas; the bulb is under high pressure, so there is a
risk of it shattering.
CAUTION:
Do NOT use any bulbs that have fallen on the ground or have scratches on their surface, as
there is a risk of them shattering.
CAUTION:
Make sure that the bulb is seated correctly in its holder in the light.
CAUTION:
Check the light for signs of damage and make sure the seals are seated correctly.
IMPORTANT:
Use only bulbs that require 12 volts and are of the same type and wattage as the bulb that is being
replaced.
IMPORTANT:
Never touch the glass surface of the bulb, hold it only by its base.
IMPORTANT:
Use a clean cloth and alcohol to remove any fingerprints from the glass bulb.
IMPORTANT:
If the tractor is fitted with halogen bulbs, never touch a halogen bulb with the fingers. Natural moisture in
the skin will cause the bulb to burn out when the light is switched on. Always use a clean cloth or tissue
when handling halogen bulbs.
4.3.1 Headlight alignment
The tractor must be in normal road-going conditions and parked on a level surface at a distance of 7.6 m
from a wall (tyres must be inflated to the correct pressures and the front wheels must be positioned for
travel in a straight line).
Switch on the low beam headlights.
GUID-73F7CA11-CFDD-47C6-BE2C-0BA477F3F381 [V2]
GUID-EFAD7E71-0727-44FF-B0FF-164CAB860B84 [V1]
4. Maintenance
F Series 159
39940211 (555124)