Examine the oil level in the front axle housing
Remove the level plug (B).
If the oil level is below the hole, fill the axle
housing to the level plug hole with the specified
fluid (see the "Lubricants and additives" section).
Install the level plug (B) and tighten to 70 Nm.
GUID-7E09B1C5-DBAC-45AE-8173-46E0577A5DF4-high.jpg [High]
Fig. 98
Drain the oil from the front axle
Put a container below the drain plug (C) to collect
the oil.
Remove the drain plug (C).
Fully drain the system.
Install the drain plug (C) and tighten to 70 Nm.
GUID-8FBB0B6F-E665-42B1-B94B-746A9A5ECCDB-high.jpg [High]
Fig. 99
Fill the front axle with oil
Remove the level plug (B).
Fill the axle housing to the level plug hole with the
specified fluid (see the "Lubricants and additives"
section).
Install the level plug (B) and tighten to 70 Nm.
GUID-7E09B1C5-DBAC-45AE-8173-46E0577A5DF4-high.jpg [High]
Fig. 100
4.12.15 Check Rops and Cab Tightness
Verify the tightness of the cab or frame mounting bolts by your dealer or agent every 2400 hours.
GUID-BC76C7BE-9C70-4309-B9EF-4C812EE73634 [V1]
4. Maintenance
196 F Series
39940211 (555124)
To Next Page
Loading...
Need help?
General
