Vatech Green 16 - Selecting an Announcement Mode (Optional)

9. Installing Software
130 Green 16/18 Installation Manual
9.7 Selecting an Announcement Mode (Optional)
When selecting an announcement between music and beep arises, take the following
procedures.
Commands specifications:
Command format: [SPM_MPOP_XXXX]
XXXX Imaging Modes
Announcement
Mode
Division
0000
CT/PANO
Music
Different for each mode
0001
CT/PANO
Music
The same for each mode
0002
(Default)
CT/PANO Beep
The same for each mode
1. Send the command following the command specification, as in the table above.
Here are some examples.
Default mode: 0002(beep) for each imaging mode.
< When the same Music Announcement is desired for CT and PANO imaging
modality >
: Enter the command [SPM_MPOP_0001] in the command field, followed by
Send.
< When the same Beep Announcement is desired for CT and PANO imaging
modality >
: Enter the command [SPM_MPOP_0002] in the command field, followed by
Send.